Installation guide glue mastic method
Glue mastic installation instruction
Important information
- Because Spaza cannot anticipate all of the different possible surfaces and contaminants that may exist, it is imperative that the user conduct an evaluation to determine the suitability of surface preparations procedures, and any other processes that may have an influence on the tape or the bonded parts. Ensure you follow required local building codes for bathroom installations.
- Before installing our products, we recommend conducting a test installation in a designated room to assess functionality and compatibility. This proactive step helps identify and address potential issues before scaling up. Evaluate performance and ensure your team is familiar with the installation process. This preliminary trial enhances overall success and instills confidence in the seamless integration of our products throughout your hotel.
- The wall surface must be even, clean, and dry. We recommend using isopropanol (IPA) 70% dilution in water and a clean lint free cloth to ensure all surface are cleaned thoroughly.
- Before installing, please make sure you have read our surface preparations and method selection section.
Position
Check surface
Make sure the contact surface flatness does not vary more than 3 mm.
Measure
Measure 48 inches (120 cm) from floor to top of bracket, and mark position of each contact surface with pencil or piece of masking tape.*
*For ADA (Americans with Disabilities Act) designated rooms – we recommend installation at 41 inches (104 cm) for accessibility.
Surface preparations
Cleaning
Clean all contact surfaces with isopropanol alcohol (IPA) to remove any greasy residue, let dry thoroughly prior to installation.
- Don't rub across the contact surface. Wipe in a vertical direction then fold the cleaning wipe to a new side and wipe a final stroke in a vertical direction.
Install product
Apply glue
Install cover plugs in the bracket screw holes.
Apply the glue to the backside of bracket.
Place
Aim the bracket to the wall in level and press to ensure glue has spread over the contact surface.
Wait
Leave bracket on the wall for at least 12 hours before use*.
* Refering to when using recommended Casco XtremFix+
Place bottle
Use Spaza key
Place the Spaza key in the key slot, move the hook aside.
Place
Place the bottle and swing back the hook around the cap.
Need assistance?
Discover the key to seamless product installation with our comprehensive guide about surface preparation and method selection for successful product installation. Gain expertise in method selection, empowering you to make informed decisions and achieve successful, lasting results.